Here are some pictures of me tapping a few holes that derrick drilled. We needed to have a 3/8" tap done so we could bolt down the casters into this stand for project Frankenstein. Derrick cleaned up the "welds" done by Eric.
Also sharpened a drill bit last week. You want the cutting edge to be higher than the following edge so it bites into the metal. If it isn't then you have a good chance of one only one drill bit edge cutting. You also want your drill bit to be centered and you can tell very quickly whether or not you've sharpened the bit properly. It literally won't cut if you don't. Some pictures of it are coming.
 |
| Tapping a hole for the bolts for a caster. |
 |
| Fresh after a weld. |
 |
| Installing the casters for Frankentruck's stand. |
\
No comments:
Post a Comment